would different tires on the front 205/60/15 and 215/70/15 on the rear cause the abs light to go on. ?

November 11th, 2008 · 3 Comments



The car is a 2002 Legacy wagon. This hapened only after the mismatched tires were installed. Can I drive the car 25 miles to the tire dealer with this light on and not cause damage as I want to have the proper tires installed. THANKS

Related posts:

  • Help on Java exercise?
  • My exercise it this: Tires don't have to have exactly the same...
  • I just bought a used truck from a dealer and the ABS module is needing to be replaced.What are the laws in Ga.?
  • I've just made my 2nd payment on my 2004 F-150 and the used car...
  • abs light and 4 wd light blinking?
  • i need help i have a 2005 mercury mariner and the abs light is on and...
  • vsc and traction control off light and abs light?
  • well the front tires on my 2003 4runner were rubbing so i installed 1...
  • ABS light on a 2003 subaru legacy?
  • I have a 2003 Subaru Legacy wagon and the abs light came on a few...
  • How do I change 2001 cadillac catera brakes with ABS?
  • Do I need any special tools or do they have any special clips...
  • 1994 Jeep Cherokee, 4X4 indicator light stays on, ABS light on, ABS not working?
  • I am looking at purchasing a 1994 Jeep Cherokee, V8, 4X4. The owner...
  • 2001 Dodge Ram 4×4 ABS Problems?
  • After replacing the Transmission Output Shaft Vehicle Speed Sensor...
  • where is the best place to a ABS speed sensor for my 1997 grand cherokee v-6, 4.0?
  • my front right tires abs keeps thinking my brakes are locking up when...
  • Should ABS brakes, leave marks on the road ?
  • Do a proper ABS brakes leaves road marks when used? I was facing a...

    Tags: Abs



    3 responses so far ↓

    • 1 moe h // Nov 11, 2008

      you wont cause and damage,your abs counts the revolutions of your tires and compares them to all 4 it also is how your traction control works.your computer is just reacting to the bad input.

    • 2 Benjamin P // Nov 11, 2008

      yes you can drive it that far. then your gonna have to have the light reset after the change if it dont go out. good luck

    • 3 Steve W // Nov 11, 2008

      yes you can and i dont think wheels would cause problem check wiring etc to pads /callipers!!!regards

    You must log in to post a comment.

     

    Sitemap Powered by Yahoo!API! All rights reserved.